 |
 |
 |
|||||||||||||
 |
 |
 |
 |
 |
 |
|
|||||||||
 |
 |
|
|||||||||||||
WELCOME TO SPROG DCC |
 |
|
|||||||||||||
 |
 |
 |
|
 |
|
||||||||||
 |
 |
|
|||||||||||||
| SPROG II is a stand-alone computer controlled programmer and controller, complementary to your existing DCC system. SPROG II is not an interface to any particular DCC system. SPROG II is supported on a range of hardware platforms (PC, MAC) and operating systems (Windows, MacOS, Linux) by DecoderPro. |
|
||||||||||||||
|
|
SPROG II is capable of generating any valid (or invalid) DCC
packet to facilitate testing of DCC components. This was originally
intended for use with a small 'tailchaser' test track or rolling road
for decoder testing, running-in, performance tuning, etc. |
|
|||||||||||||
 |
Decoder Pro from JMRI can be used to configure and program DCC Decoders |
|
|||||||||||||
| For small layouts, Sprog 2 can also be used as a command station/booster |
|
||||||||||||||
 |
 |
|
|||||||||||||
| SPROG II gives you the ability to program DCC decoders using your computer without the need to move your computer to the railway room, or your existing DCC system to the computer room. SPROG II accepts commands from the computer's USB port and formats them into DCC packets for programming of decoders or operating small layouts or DCC accessory systems. |
|
||||||||||||||
 |
|
||||||||||||||
| SPROG II should work with any DCC decoder conforming to NMRA standards. Whenever possible, any compatibility issues will be addresses as part of SPROGs ongoing development. |
|
||||||||||||||
 |
Supports the DecoderPro throttle with version 1.3 or later firmware for the function buttons |
|
|||||||||||||
| SPROG II can be used as an interface between PanelPro and a DCC accessory bus. |
|
||||||||||||||
 |
|
||||||||||||||
| Copyright © 2010 SprogDCC.com |
|
||||||||||||||
 |
|
||||||||||||||
| Main Page | Purchase | Downloads | Links | About | Contact |
|
||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|